BCM-6150 Bench for the Control and testing of bearings




Add to wishlist

The bearing condition monitoring stands BALTECH BCM are intended to check rolling element bearing condition before their installation.

The bearing condition monitoring stand BALTECH BCM in designed for:

  • Automatic diagnostics and testing of rolling element bearings
  • Selection of qualitative bearings
  • Registration and analysis of vibration signals
  • Bearing database management

The stand was designed according to the standard ISO 15242-1:2004 (Rolling bearings. Measuring methods for vibration. Part 1. Fundamentals) on the basis of the vibration measurement technique for rolling element bearings with cylindrical holes. This measurement technique is applicable to the following bearing types, including those with one and two protective washers and sealing:

  • single-row and double-row radial ball bearings;
  • single-row and double-row angular ball bearings;
  • cylindrical roller bearings;
  • tapered roller bearings;
  • single-row and double-row spherical radial roller bearings;
  • single-row and double-row spherical radial thrust roller bearings

The above mentioned measurement technique is recommended for use by those enterprises that use the rolling element bearings. The bearing diagnostics stand BALTECH BCM was designed in association with the specialists of the bearing plants.

Bearing inner diameter, mm 7 – 150
Bearing outer diameter, mm Up to 300
Bearing width, mm Up to 90
Sensor 1 vibration sensor
Sensor frequency range, Hz 25 - 10 000
Bearing rotation frequency during diagnostics, rpm 1800/900 (frequency-regulated drive)
Bearing radial load , N 30 – 1000 N
Bearing axial load , N 0 – 1200
Time required for diagnostics of one bearing exclusive of time required for bearing mounting and dismounting , sec. 15-60
Computer type Terminal
Weight, kg 600,0±10,0 kg
Dimensions, mm 1015х950х1473
Supply voltage 220 V, 50 Hz

1 other products in the same category: