U-DT-2 HOBO Data Shuttle for field data offload View larger

U-DT-2 HOBO Data Shuttle for field data offload




278,00 €

Add to wishlist

The HOBO U-DT-2 U30 Shuttle Data Transporter provides convenient in-field data offload and relaunch of HOBO U30-NRC systems and HOBO Weather Stations (H21), Micro Stations, and HOBO Energy Logger systems (H22). The U30 Shuttle's 2 x 16-character display shows current readings (for selected loggers), and logger status.

The HOBO U30 Shuttle performs the following major functions:

  • Reads out data from systems in the field for transfer to a host computer
  • Optionally relaunches the logger — synchronizes the logger’s clock with the shuttle’s clock and (in most cases) sets logging to begin at the next interval
  • Preserves data in nonvolatile memory, even if batteries are depleted
  • Displays logger status, including memory, battery level, and sensor readings
  • Displays its own status, including clock, memory, and battery level
  • Lets you change the batteries in the field without resetting the clock
  • Allows you to test individual smart sensors
The U-DT-2 is for use in Indoor and Outdoor environments

USB cable (provided); compatible logger with appropriate cable and/or base station
U-DT-2: HOBOware 2.6 or greater

HOBO U30 series systems, HOBO Weather Stations and Micro
Stations (H21), and HOBO Energy Logger (H22)

Firmware upgrades:
Available on the Onset website as needed to provide compatibility with future supported logger models

Operating temperature 0° to 50°C (32° to 122°F)
Storage temperature -10° to 50°C (14° to 122°F)
Time accuracy ± 1 minute per month at 25°C (77°F)

Logger-to-shuttle transfer speed:
USB 64K in approximately 30 seconds
Serial: 512K in approximately 60 seconds

Shuttle-to-host transfer speed:
Full shuttle offload (4 MB) to host computer in 3 to 5 minutes, depending on computer

Data capacity (full loggers):
4 MB (minus 64 KB for shuttle information): enough for 7 readouts of 512K loggers

Idle timeout:
Shuttle powers down after two minutes of idle time, except when actively communicating with HOBOware (see HOBOware User’s Guide for details) or changing logger batteries

RJ-12 jack for communicating with smart sensors; mini-B full speed USB port for communicating with host computer; full speed USB port for communicating with U-Series loggers and base stations; high speed serial port for communicating with serial loggers.
Shuttle communicates with only one device at a time.

Main: 2 AA alkaline batteries
Clock backup: 1 CR1225 lithium battery (3 V)

Battery life:
Main: One year or approximately 50 complete memory fills, typical use
Clock backup: 10 years typical use (with main batteries installed)

Weight: 153 g (5.4 oz)
Dimensions: 11.0 x 6.9 x 2.7 cm (4.35 x 2.70 x 1.05 inches)
Case materials: ABS case with urethane rubber grips, polycarbonate label.

6 other products in the same category: