Two-Part Pyrometer for High Temperature and Metals Objectives (100°C to 2000°C)
PT models: 100°C to 400°C
MT models: 250°C to 1000°C
HT models: 450°C to 2000°C
Two-part Pyrometer for High Temperature Targets and Metals (100°C to 2000°C)
The PyroMini 2.2 Series is a range of short-wavelength miniature non-contact infrared temperature sensors with separate electronics modules.
All models use a short measurement wavelength for greater accuracy, and improved tolerance of optical obstructions or errors in emissivity setting, than long-wavelength sensors.
The optional touch screen display on the electronics module provides temperature indication, alarms, configuration and data logging to MicroSD Card.
A choice of optics is available for the accurate measurement of small or large targets at short or long distances, and there is a choice of 4-20 mA, RS485 Modbus and alarm relay outputs.
Temperature ranges from 100°C to 2000°C
Short wavelength measurement for better accuracy on reflective targets such as many metals
4-20 mA or RS485 Modbus outputs
Miniature sensing head and configurable electronics module
Touch screen interface (optional)
Data logging to MicroSD Card (optional)
The PyroMini 2.2 series conforms to EMC Directive EN61326-1:2006 (Electrical equipment for measurement, control and laboratory use – Industrial) as well as industrial standards for electromagnetic immunity and emissions.
6-channel touch screen hub for temperature display, alarms, configuration and data logging, compatible with PyroMini Modbus models, PyroMiniBus and PyroBus sensors. Isolated RS485 Modbus master and slave interfaces allow multiple hubs to be connected to a larger network. Optional modules provide analogue and relay outputs.
The air purge collar is used to keep dust, fumes, moisture and other contaminants away from the lens. Air flows into the fitting on the side and out of the aperture at the front.
The L-shaped fixed mounting bracket offers a rigid support for the sensor and allows fine rotational adjustment about one axis.
The adjustable mounting bracket consists of a fixed mounting bracket plus another L-shaped bracket. When assembled as shown, the adjustable mounting bracket offers a rigid support for the sensor and allows fine two-axis adjustment.
The Laser Sighting Tool screws onto the front of the sensor during installation and shows precisely where the sensor is aiming. Once the sensor has been aimed at the centre of the target and locked in position, the Laser Sighting Tool can be removed. The laser is operated via a latching push button on the front of the tool.
The Dual Laser Sighting Bracket is a sturdy mount for the sensor and provides continuous target sighting while measurements are being taken. Two parallel lasers indicate the centre of the measured spot and are controlled by a remote switch on the electronics module.
When fitted over the lens of the sensor, the protective plastic window in stainless steel holder provides mechanical protection and helps retain fragments of lens in case of damage. Adjust the sensor’s emissivity setting to compensate for the presence of the window for maximum accuracy. This accessory is ideal for the food and pharmaceutical industries.
The 4-20 mA output of PyroMini 2.2 -CB and -CRT models may be connected to any of our indicating controllers for PID control.
1 085,00 €
1 085,00 €
1 085,00 €
1 085,00 €