HI-1670 Induction Heaters (+240ºC Max.)




Induction Heaters (+240ºC Max.)

Add to wishlist

Installation of gear drives and replacement of large- size bearings, rings and couplings is easily conducted with the induction heater BALTECH HI-1670. The induction heaters BALTECH HI Series are the pledge of qualitative assembling and dismantling of bearings and gear drives.

The induction heater BALTECH HI-1670 weighing 200 kg is intended to heat large- size bearings of up to 560 kg with a minimum inner diameter 60 mm and maximum outer diameter 1020 mm. The induction heating of bearings and gears can be conducted both vertically and horizontally. If you need to heat a part of a considerable weight and large size, BALTECH will manufacture a special stationary induction heater according to your technical requirements.

Advantages of the BALTECH HI Series induction heaters:

  • Heating temperature control
  • High reliability assurance during hard routine work
  • Ease of use
Model BALTECH HI-1670
Nominal power , kVA 12
Voltage , V/Current,А 380/32
Frequency, Hz 50
Rotatable yoke Yes
Heated part
Maximum bearing weight, kg 560
Minimum inner diameter d, mm 60
Maximum outer diameter D, mm 1020
W, mm 380
H, mm 250
Yoke dimensions
Yoke width, mm 40;60;85
Yoke length, mm 600
Control panel
Temperature setting, °С
Maximum temperature, °С
Automatic power reduction Yes
Dimensions, mm 1390х600х1080
Heater weight (without yoke), kg 200

9 other products in the same category: