RSTAR L900 Wireless Data Acquisition for Geotechnical Instruments

RSTAR L900

RST Instruments

New

The RSTAR Array Radio Series uses wireless technology to provide automated data acquisition.
 
 *   Fully compatible with RST “DT Series” Data Loggers.
 *   Excellent Hub – Node range (up to 14 km in open country).
 *   Ultra-low quiescent power. RSTAR Nodes powered by a single lithium cell which provides years of battery life.
 *   Simple star routing – no mesh overhead.

Add to wishlist

Environment of Use Outdoor
Type of Logger Portable
Measured Parameters Multiple Parameters
Application Geotechnics

The “DT Series” Data Loggers from RST accommodate the RSTAR Data Collection System and use a single lithium standard cell which provides years of battery life (model dependent).
The DT Series provides reliable, unattended monitoring of various sensor types:
- vibrating wire sensors
- potentiometers
- MEMS tilt sensors
- strain gauge (full bridge) sensors
- digitally bussed (DT-BUS) sensors
- 4-20 mA sensors
- thermistors.

A complete RSTAR L900 System uses L900 RSTAR Nodes at the sensor level, deployed in a star topology from a continuously active L900 RSTAR Hub, which consists of an L900 RTU interfaced to a FlexDAQ Data Logger.
The RSTAR Array Radio Series is based on the 900 MHZ, 868 MHz, and 2.4 GHz spread spectrum band (country dependent) with extensive open-country range through use of simple dipole or directional antennae.

Power requirements for a single RSTAR L900 node is one lithium standard cell. The FlexDAQ can be powered by a solar panel, batteries, or AC power.